Launch the Software.

On the main window, click the “Open pattern from database” button on the main toolbar at the top.

Find the pattern in the Database Access Tool and click “Open”.

The pattern will open in the main window, where you can select specific parts and send them to the plotter.

Our designers always try to make it easier for customers to select the correct part. Some parts may have different colors, like in the picture above. There is always a note describing why parts have different colors; please read it carefully, as it gives insight into compatibility and fine adjustments you may encounter while installing the film.

<aside> 💡

The red dotted lines show the roll width. Every plotter has a maximum width for the roll it supports. The program will automatically set the maximum allowed width depending on the selected plotter.

</aside>

Next: Test Cut